Ariston 100 L - Wi-Fi, Maintenance, and Disposal

Hybrid electric water heater (WiFi model) – OPERATING AND MAINTENANCE INSTRUCTIONS FOR THE USER
127
231
Medium/low NTC sensor
(heating element zone):
protection activated (1° level)
OFF OFF
232
Low NTC sensor (heating
element zone): protection
activated (2° level)
OFF OFF
240
Impressed current anode: short
circuit
OFF OFF
Reset the product by pressing the
ON/OFF key twice. If the error re-
occurs, replace the main circuit board
241
Impressed current anode: open
circuit
OFF
OFF
Check for the
presence of water
inside the product: fill, if necessary.
Check, and if necessary correct, the
anode connection to the main circuit
board. Check, and if necessary,
correct the connections on the flange:
black wire on the anode, white wire on
earth
Electronic circuit codes key
314 ON/OFF repeated OFF OFF
Wait for at least 15 minutes before
unblocking the product. Press the
ON/OFF key twice
321 Main circuit board issue OFF OFF
Reset the product by pressing the
ON/OFF key twice. If the error re-
occurs, replace the main circuit board
333 Error Wi-Fi board ON ON
Reset the product by pressing of
ON/OFF button two times. If the error
appear again replace the
communication cable MB - Wi-Fi. If
the error appear again replace the Wi-
Fi board
7.16 Function Wi-Fi
Setup Wi-Fi
For detailed information on the WiFi configuration and product registration procedure refer to the enclosed, dedicated
connectivity Quick Start Guide.
• Account Creation
1. First download and install the dedicated App on your mobile phone (App name can be found in the
quick start guide).
2. Open the App, click on the SIGN UP button and fill in all the fields
3. Open the registration reply message received in your mailbox and click on the link to activate the user
account.
• Wi-Fi configuration and product registration
1. Touch the Wi-Fi button and the Wi-Fi button indicator
lamp will flash slowly.
2. Press the Wi-Fi button again for 5 seconds, the Wi-Fi
button indicator lamp will flash quickly (13 flashes per second),
meanwhile, the display will show AP" icon (see pic.).
3. Log it to the App and follow the wizard
4. The connection is successful when:
- the 'AP" icon disappears and the WI-FI icon appears on the display;
- the Wi-Fi indicator lamp will stay on and steady;
- the App shows the successful registration message.