Hybrid electric water heater (WiFi model) – GENERAL INFORMATION
108
C 225 219
D 1/2” cold water inlet pipe
E 1/2” hot water outlet pipe
F Lower cover
G Cap
H Handles
I Capacitor
J Wall support bracket
K Wall spacer
L Heat pump front guard
M Removable rear heat pump guards
N Tank fastening covers (accessory)
O Power supply cable
P User interface panel
Q Installation plate (accessory)
R Condensation drain connection
2.4 Electrical diagram
(See Fig. 4)
A Power supply cable
B Power supply terminal block L / N
C Earthing pin
D 1200W electrical heating element
E Compressor start capacitor
F Flange heating element
G Compressor
H Compressor thermal protection switch
I Impressed current anode
J RJ45 serial port
K NTC hot water sensor
L NTC evaporator sensor
M NTC air sensor
N Condensate tank microswitch
O P.C.B.
P Fan
Q WiFi electronic board
2.5 Technical data table
Description
Unit
80 L 100 L
Rated tank capacity
l 80 100
Minimum distance from upper wall (See Fig. 6) mm 50
Minimum distance from side wall (See Fig. 6) mm 200
Minimum distance from floor (See Fig. 6) mm 500
Insulation thickness
mm ≈23 ≈23
Type of internal tank protection
enamelling
Type of corrosion protection
titanium impressed current anode + disposable
magnesium anode
Maximum operating pressure
MPa 0,8
Diameter of hydraulic connections
II
1/2 M
Minimum water hardness
°F
12 (min 15 °F with softener)
Minimum conductivity of the water
µS/cm 150
Weight when empty
kg 37,5 44
Heat pump
To Next Page
Loading...
