be removed:
2. Use a screwdriver to lift up and turn the small levers F
F
3. Grip the door on the two outer
sides and close it approximately
half way. Pull the door towards you,
To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of
the lamp-holder.
2. Remove the light bulb and
replace it with a similar one:
Wattage 25 W, cap E 14.
3. Replace the glass cover
!
Side and rear catalytic liners*
These are panels coated with a special enamel, which is
able to absorb the fat released by food as it cooks.
This enamel is quite strong, so that the various accessories
these are not a cause for concern.
Nevertheless, the following should be avoided:
- using detergents or abrasive materials.
* Only available in certain models.
To Next Page
Loading...
