Axon x700 Control Panel User Manual 19
The Axon x700 menu
The Axon x700 system uses a menu structure to present the various options and
commands available. The availability of these depends on system configuration
and on the permissions in your user group. You may not always see all the items
described in this manual.
If you access the menu and do not press any key for three minutes, the system
time out function automatically exits from the menu. It is good practice to make
sure you exit the menu using the Clear button rather than this time out facility. If
someone else uses the menu before it times out, the options used will be logged
against your user account.
If you attempt to select an option that is not authorised in your user account, the
display shows the message:
Although you might be authorised to access a menu option, you might not be
allowed to access all the information it provides. You are only allowed to access
information for the areas assigned to your user account.
Area selection
Depending on the system settings and your user group, you may be prompted to
choose areas that you are going to operate on.
The area selection list is the same as the set/unset area list. See “Areas
displayed during set and unset” on page 13 for details.
The selected areas will be excluded from normal operation. Other users will not
be able to control these selected areas until you exit the menu.
Note: Door access functionality is not affected by the programming mode.
How the menu option sections are organised in this
manual
Menu options are numbered in the Axon x700 system. This numbering system is
also used in this manual, so menu option 1 “Inhibit zones” is topic “1 Inhibit
zones”.
The menu number also refers to the key sequence that can be pressed to enter
the menu. For example, if you want to enter menu “7.2 Walk test”, you can press
7, then 2 after entering the menu system.
Option availability
Not all options described below may be available. Option availability depends on
the following:
To Next Page
Loading...
