AZI Customer Service 800-528-7411 or 602-470-1414 Page 35 of 92
CUT Memory Start
This command removes a memory
start, which can be optionally inserted
at another location. Use this
carefully. The “(Factory)” memory
starts cannot be deleted with this
option.
COPY Memory Start
To quickly create a new set similar to an old one, use [COPY] from one location, move
the highlight bar to the desired location and [INSERT↑] or [INSERT↓] into a new
location.
Highlight the memory start set you wish to copy.
Press [COPY].
Using the Up and Down Arrow Keys highlight the location where you want the
new memory start to be and press [INSERT↑] or [INSERT↓].
The contents of the locations are safe. Memory starts above the insert will not be
affected and memory starts below the insert will be moved down the list
INSERT Memory Start
Pressing [INSERT↑] or [INSERT↓] will insert a new memory start either above or
below the cursor location and move the following memory starts down.
To Next Page
Loading...
Need help?
General
