Arjo MAXI MOVE - Preventive Maintenance Schedule

KEY: X = Action required on the part of the customer S = Action required on the part of a qualified service technician
4
Action
DPS Spreader Bars Loop Spreader Bars
Manual Powered 2-4 Point Stretcher
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Visually inspect the condition of all
sling attachment points for damage. If
any is found, replace with new unit.
X X X X
Make sure all instruction labels are
attached and readable. Replace as
required. See “Operating Instructions”
for location of labels.
X X X X
Check the condition of the friction discs
and bushings within the pivot points. If
found worn and/or damaged, parts must
be replaced. See Fig. 5.
S S
When the friction discs and bushings
have been checked/replaced, reset the
friction assembly and verify that the
handle can support a 5.4 kg (12 lb)
weight load.
S S
Visually inspect all external parts,
making sure no damage has occurred
during use. Replace parts as required.
S S
Make sure the unit can be powered
through the full range smoothly.
S
Examine all exposed parts, especially
where there is close contact with the
patient’s body. Make sure no cracks or
sharp edges have developed that could
cause injuries or become unhygienic.
Replace where necessary.
X S X S X S X S
Preventive Maintenance Schedule
001.25065.EN rev. 9