Arjo MAXI MOVE - General Information; Intended Use

KEY: X = Action required on the part of the customer S = Action required on the part of a qualified service technician
5
Inspect the condition of the leaf spring
and locking clip at the attachment point.
Replace if damaged.
X S X S X S X S
Visually inspect that the spreader bar
correctly installs on the jib, i.e. that the
plastic clip latches into the groove on
the “T” part on the jib.
X X X X
Visually inspect to make sure the leaf
spring within the locking clip is
correctly installed. See Fig. 6.
X X X X
Action
Maxi Move Accessories
Slings Battery Charger
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Examine for damage/fraying to sling, straps and clips; replace as required.
X S
Visually examine the battery charger for loose connectors, cut wires,
damaged casing etc. Do not use if damaged in any way.
X S
Make sure the battery is in a good state of charge. See “Operating
Instructions” for the battery charging procedure.
X S
Action
DPS Spreader Bars Loop Spreader Bars
Manual Powered 2-4 Point Stretcher
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Before
Every Use
Every
Week
Every 12
Months
Every 2
Years
Preventive Maintenance Schedule
001.25065.EN rev. 9