Arjo SARA PLUS User Manual (English)

Other manuals for Arjo SARA PLUS

Questions and Answers:

H
huffmarisaAug 19, 2025
What to do if Arjo Medical Equipment Sara Plus hoist moves unexpectedly?
- C
  Casey WalkerAug 19, 2025
  If the hoist moves unexpectedly, and releasing the buttons does not work, push the red Emergency stop button and remove the battery. Use the System failure lowering override to put the patient back into a safe seated position, then remove the Sara Plus from use. Do not use the equipment again until it has been inspected and passed for safe working by an Arjo approved service engineer.
K
kedwardsAug 20, 2025
How to correctly position a patient in an Arjo Sling?
- A
  Ashley HughesAug 21, 2025
  To correctly position a patient in the Arjo Sling, ensure the clip/lift cords are attached at the right length, and the straps aren't twisted or knotted. Position the patient inside the sling, using the label as a reference, and ensure they are centered. Check that there are no creases on the leg flaps and that they are attached at the correct length. Verify the clip isn't caught. Use the sling according to the allowed combinations. Adjust the patient’s position using the clips/lift cords, or inner clips, and adjust the support belt for comfort. Ensure the patient is holding onto the handles on the lift.
J
Joshua WalkerAug 23, 2025
What to do if patient feels discomfort in leg area with Arjo Sling?
- A
  Anthony PerryAug 23, 2025
  If a patient feels discomfort in the leg area when seated in the Arjo Sling, make sure the clip/lift cords are attached at the right length. Also, check that the straps are not twisted or that there are no knots on the lift cords. Ensure the patient is centered in the sling, and that there are no creases on the leg flaps. Finally, make sure the leg flaps are attached at the right length.
C
Cassandra BoydAug 26, 2025
What to do if Arjo Sling slides up under patient's arms?
- J
  Jeffrey BrownAug 26, 2025
  If the Arjo Sling is sliding up under the patient’s arms, ensure the patient is positioned on the inside of the sling, using the label for reference. Also, make sure the patient is centered in the sling. Check that there are no creases on the leg flaps and ensure the leg flaps are attached at the right length.
N
Nicole GoldenAug 27, 2025
How to handle a soiled Arjo disposable sling?
- M
  Michele HudsonAug 27, 2025
  If the disposable Arjo sling is soiled, stained, or wet, throw it away and replace it with a new one.
A
Angel ManningAug 30, 2025
What to do if 'Do NOT wash' label is damaged on Arjo Sling?
- M
  Michael DoyleAug 30, 2025
  If the “Do NOT wash” label is damaged or missing on the disposable Arjo sling, and the underlying red label “Do NOT use/lift” is visible, discard the sling and replace it with a new one.
D
David JohnstonSep 1, 2025
What to do if Arjo Flites Sling is soiled, stained, or wet?
- D
  daniel23Sep 1, 2025
  If the Arjo Flites Sling becomes soiled, stained, or wet, dispose of it and replace it with a new one.
T
Trevor WrightSep 3, 2025
What to do if Arjo Medical Equipment Sara Plus support arms do not move upwards and overload is displayed?
- L
  Lonnie HoltSep 3, 2025
  If, when pressing the “Raise” button, the Sara Plus makes a noise, “overload” is displayed, and the buzzer beeps continuously but the resident support arms do not move upwards, it may be that the resident support arms are blocked by an obstruction. Remove the obstruction and check the Sara Plus thoroughly for damage before continuing the lifting cycle. If in doubt, use the System failure lower override to return the resident to a safe seated position, then remove the Sara Plus from use. Do not use the equipment again until it has been inspected and passed for safe working by an Arjo approved service engineer.
S
Steven MoyerSep 6, 2025
What to do if Arjo Medical Equipment Sara Plus chassis legs do not open and overload is displayed?
- S
  sharon89Sep 6, 2025
  If, when the “Chassis legs open” button is pressed, the Sara Plus makes a noise, “overload” is displayed, and the buzzer beeps continuously but the chassis legs do not open, it may be that the chassis legs are blocked by an obstruction. Remove the obstruction and check the Sara Plus thoroughly for damage before continuing the lifting cycle. If in doubt, use the System failure lower override to return the resident to a safe seated position, then remove the Sara Plus from use. Do not use the equipment again until it has been inspected and passed for safe working by an Arjo approved service engineer.
T
Timothy TaylorSep 8, 2025
What to do if Arjo Medical Equipment Sara Plus does not raise or lower with the hand control?
- A
  Antonio MillerSep 8, 2025
  If the Sara Plus does not raise or lower and the chassis legs cannot be opened or closed when using the hand control, the hand control may be damaged. Try operating the Sara Plus with the Dual up/down control located on the mast. If the equipment functions correctly when using these controls, the hand control should be replaced.

Arjo SARA PLUS Specifications

General

Safe Working Load	200 kg
Battery Type	24V
Total Height	1200 mm (47.2 ")
Leg Height	Adjustable
Knee Pad Height Adjustment	Adjustable
Lift Mechanism	Electric
Height Adjustment	Electric
Wheel Configuration	4 castors
Footplate	Adjustable