Why do Arjohuntleigh Lifting Systems Alenti functions only operate with the control panel?
If your Arjohuntleigh Alenti Lifting System functions only operate with the use of the control panel, not the hand control, ensure that the hand control connection is properly connected to the socket. If the problem persists, replace the hand control.
What to do if the Alenti lift does not raise or lower when the hand control button or the control panel button is pressed?
If the Alenti lift isn't raising or lowering when you press the buttons, check these things: 1. Make sure the battery is correctly connected. 2. Ensure the battery has enough charge; the charger lamp turns green when it's full. 3. Confirm the lift hasn't been lowered onto something, activating the safety stop function. 4. If so, use the Emergency High/Low to remove the patient. Contact qualified personnel.
Why is the Alenti lift hard to maneuver?
If the Alenti lift is hard to maneuver: 1. Make sure that the brakes are released. 2. Make sure that the castors roll and swivel freely. If not, remove the patient from the Alenti lift and contact qualified personnel.
What to do if the Alenti lift functions only operate with the use of the control panel, not the hand control?
If the Alenti lift functions only operate with the control panel, not the hand control: 1. Make sure that the hand control connection is properly connected to the socket. 2. If the problem persists, replace the hand control.
What to do if the Alenti lift raises or lowers after the hand control button or the control panel button is released?
If the Alenti lift raises or lowers after releasing the button: 1. Pull the battery out and remove the patient from the Alenti lift. 2. Remove the hand control and put the battery back. If the issue is resolved, replace the hand control. 3. If it continues, contact qualified personnel.
What to do if there is a circuit board fault with Arjohuntleigh Lifting Systems Alenti?
If the alarm for circuit board fault starts while the resident is using the Arjohuntleigh Alenti, complete the immediate task such as bathing or transfer. Then contact your local ArjoHuntleigh service technician.
How to clear the low battery signal on ArjoHuntleigh Lifting Systems?
Recharge the battery of your ArjoHuntleigh Lifting System. If the alarm continues, contact your local ArjoHuntleigh service technician.
What to do for a brake fault on Arjohuntleigh Lifting Systems Alenti?
Try moving the Arjohuntleigh Alenti to a flat leveled surface and re-apply the brakes. If the alarm continues contact your local ArjoHuntleigh service technician.
What to do if brakes are not functioning on Arjohuntleigh Lifting Systems?
If the brakes on your Arjohuntleigh Alenti Lifting System are not functioning, first ensure that Alenti is on a flat, leveled surface (the floor surface must not exceed a slope ratio of 1:50). If the brake alarm sounds, try moving the Alenti to a flat leveled surface and re-apply the brakes. If the alarm continues, contact qualified personnel.
How to troubleshoot hard maneuvering of Arjohuntleigh Lifting Systems Alenti?
If your Arjohuntleigh Alenti Lifting System is hard to maneuver, first ensure that the brakes are released. Next, check that the castors roll and swivel freely. If they don't, remove the resident from the Alenti and contact qualified personnel.
Introduction to the product, service contact, and definition of terms.
Defines product usage and criteria for resident suitability.
Crucial safety advice to prevent hazards like tipping, falling, fire, and entrapment.
Steps for initial setup, daily checks, and disinfection procedures.
Lists and identifies all parts of the Alenti lift with corresponding numbers.
Explains control panel, hand control, handles, brakes, back rest, and emergency functions.
Description and usage of optional scale, bedpan holder, and leg support.
Step-by-step guide on how to use and fasten the safety belt.
General precautions and detailed steps for resident transfers.
Covers transfers from standing, wheelchair, bed, and raising aids.
Steps for toilet positioning and bathing procedures.
Explains scale display, units, verification, calibration, and weighing methods.
Guidelines for storing, handling, disposal, and low charge warnings.
Procedures for cleaning and disinfecting the lift after use.
Schedule for daily, weekly, and yearly checks by caregivers and qualified personnel.
Daily and weekly checks to be performed by the caregiver.
Common issues, solutions, and alarm signals with their meanings.
Technical data including SWL, weight, dimensions, power, operation, and storage.
Visual representation of the lift's dimensions with measurements.
Information on certifications, labels, and electromagnetic compatibility.
Lists optional accessories like scales, bedpans, and leg supports.
General| Brand | Arjohuntleigh |
|---|---|
| Model | Alenti |
| Category | Medical Equipment |
| Language | English |
To Next Page