Arjohuntleigh Maxi Twin

Other manuals for Arjohuntleigh Maxi Twin

Questions and Answers

N
nealstephenAug 12, 2025
What to do if Arjohuntleigh Lifting Systems lift does not raise or descend?
- S
  smithtracyAug 12, 2025
  If your Arjohuntleigh Lifting Systems lift isn't raising or descending, check the following: 1. Ensure the battery is fully connected in its compartment. 2. Verify the hand control connection plug is properly connected to the socket. 3. Confirm the battery is charged. 4. Ensure the emergency stop button is inactivated by turning the red knob clockwise. If these steps don't resolve the issue, use the emergency lowering feature (pull the purple ring up) to lower the resident. Once lowered, remove the resident from the lift and contact qualified personnel.
K
Kayla CooleyAug 16, 2025
What to do if Arjohuntleigh Lifting Systems lift raises or lowers after releasing buttons?
- G
  Gavin HuntAug 16, 2025
  If your Arjohuntleigh Lifting Systems lift continues to raise or lower after you release the hand control buttons, immediately activate the red emergency stop button and pull the battery out. Then, remove the resident from the lift and contact qualified personnel.
B
Barbara DeanAug 19, 2025
Why does my Arjohuntleigh Lifting Systems lift make a buzzing sound when raised?
- R
  Ruben HallAug 20, 2025
  If you hear a buzzing sound as your Arjohuntleigh Lifting Systems lift is raised, it indicates that the battery needs charging. Complete the current transfer operation and then replace the battery with a fully charged one. To avoid injury, do not leave the resident unattended.
A
Amanda ChavezAug 23, 2025
What to do if Arjohuntleigh Lifting Systems lift is hard to maneuver?
- K
  Kelly GarciaAug 23, 2025
  If your Arjohuntleigh Lifting Systems lift is difficult to maneuver during transfer, ensure all brakes are released and that all castors roll and swivel freely. If the castors do not roll and swivel freely, remove the resident from the lift and contact qualified personnel.
R
Robert MeyersAug 27, 2025
What to do if Arjohuntleigh Lifting Systems lift stops during lowering or raising?
- J
  John SheltonAug 27, 2025
  If your Arjohuntleigh Lifting Systems lift stops its motion while being lowered or raised, or when the spreader bar is moved, it may be because the lift has been lowered or raised against a fixed object. Carefully raise or lower and reposition the lift to resolve this.
Z
Zachary AdamsAug 30, 2025
What to do if Arjohuntleigh Lifting Systems lift makes abnormal sounds?
- I
  iharperAug 30, 2025
  If your Arjohuntleigh Lifting Systems lift is making abnormal sounds during lifting or transfer, remove the resident from the lift and contact qualified personnel.
J
James ChambersSep 4, 2025
What to do if Arjohuntleigh Lifting Systems lift can only be lowered?
- M
  Michael DuarteSep 4, 2025
  The lifting device of this equipment is equipped with a safety nut. In case of this scenario stop using the Arjohuntleigh Lifting Systems equipment and contact qualified personnel for repair of the equipment.
N
nancy69Sep 7, 2025
Why does Arjohuntleigh Lifting Systems battery indicator flash quickly?
- D
  Darren RichSep 7, 2025
  If the battery indicator on your Arjohuntleigh Lifting Systems lift flashes and sounds after only a few uses, replace the battery with a fully charged one. If this continues with a freshly charged battery, it's time to order a new battery.