21
Armstrong International
221 Armstrong Blvd., Three Rivers, Michigan, 49093 - USA
armstronginternational.com/brain
Valve State -
Allows the user to manually switch between the Blend
Mode (ON) and the Recirculation Mode (OFF).
Disinfection Setpoint -
This is the temperature at which the thermal disinfection
will be carried out (must not exceed 185 °F / 85 °C).
Disinfection Timeout -
This is the number of minutes the error alarm is disabled
to allow for disinfection and cool down of the blend circuit
before switching back on automatically, i.e. if Disinfection
Timeout is set to 100 minutes then the DRV25 has that
time to complete the disinfection and cool down before
entering an over temperature error condition and switching
to full cold.
Please note the following:
• Disinfection Timeout starts when the disinfection cycle is
triggered. (Refer to the “Thermal Disinfection” section
on pages 24 - 29 for more details)
• During the Disinfection Timeout, the disinfection and
cool down must be completed manually and the DRV25
returned to Setpoint (normal operation within the setpoint
limits).
• The Disinfection Timeout can be set up to a maximum
of 1800 minutes (30 hours).
Modbus Address -
This is the Modbus Network address of the DRV25 (1 - 31)
Device ID -
Update the device ID, alias as required to give the DRV25
a more meaningful name. e.g. “Bayfront Loop 1”
Disinfection Enabled -
This is the master disinfection enable switch. It must be set
to the ON position before disinfection can be carried out.
Reboot -
Forces the DRV25 to reboot. This will potentially
deliver full hot water whilst this is carried out. This
function can be used to clear some error conditions.
Redémarrage -
Oblige le DRV25 à redémarrer. Cette opération va
éventuellement aboutir à la libération d’une eau très
chaude. Cette fonctionnalité peut servir à corriger
certains cas d’erreurs.
Options
To Next Page
Loading...
Need help?
General
