Aros SENTRY MPS-HP - Personalizations Menu

page 58 / 75 0MNA080A55-GB REV 01
2=Rated Output Volt.. 3=Battery 8=Stby
4=Pre-alar
m
5=Code. 6=Auto-OFF 7=Othe
r
RATED OUTPUT VOLTAGE
BATTERY
PRE-ALARM
Code ? ......
AUTO-OFF VA
OPERATION IN STANDBY-ON
5.4.5.2 PERSONALIZATIONS
The "PERSONALIZATIONS" menu is accessed by means of key 5 from the COMMANDS menu, an intermediate
menu will then be displayed in which a CODE has to be entered. All the CODES shown below are available.
Access by CODE ensures that unauthorized persons cannot modify the operating parameters of the
equipment.
The use of the codes to modify the operation of the equipment (such as the frequency converter, stabilizer, rectifier
start-up delay, etc.) are the prerogative of the service personnel.
The activated codes may be displayed (if present) with the following sequence of keys from the basic menu: 7 + 4
then by scrolling through the alarms with keys 7 and 8.
The following message will be displayed:
System Autorestarting Disabled. = 1
Option= 41, (Tot.active= 1). 8=next
5.4.5.3 Keys menu 3, 5 : CODE 436215
The code is no longer required for 2 minutes after it has previously been inserted.
The next menu can only be accessed by inserting the correct code, otherwise it returns to the basic menu.
2
3
4
5
6
8
menu 3, 5, 436215, 2
menu 3, 5, 436215, 3
To insert new code
menu 3, 4, 436215, 3
menu 3, 6, 436215, 3
menu 3, 6, 436215, 8
Code present
1 = code active
N
ext code, if
present
N
umber of code
N
umber codes inserted
2=By Volt. Range 3= By. Freq. Range
4=Modem 5=RS232
;
6=Echo 7=Ident.
BYPASS VOLTAGE RANGE
BYPASS FRE
Q
UENCY RANGE
MODEM
RS232
E
C
H
O
IDENTIFICATION
2
3
4
5
6
7
menu 3, 5, 436215, 7, 2
menu 3, 5, 436215, 7, 3
menu 3, 5, 436215, 7, 4
menu 3, 5, 436215, 7, 5
menu 3, 5, 436215, 7, 6
menu 3, 5, 436215, 7, 7
7