Array electronic 372 Series User Manual

28
CV current limit Current limit in CV mode 40A
Voltage Hlevel Transient high voltage
level
80v
Voltage Llevel Transient voltage low level 80v
Resistance level Immediate resistance level
2000Ω
Resistance Hlevel Transient high resistance
high level
2000Ω
Resistance Llevel Transient resistance low
level
2000Ω
Power level Immediate power level 0W
Transient operation Transient test off
Transient mode Transient mode continuous
Transient Htime Time for transient high
level
0ms
Transient Ltime Time for transient low
level
0ms
Transient Rtime Time for transient rising
edge
0.01ms
Transient Ftime Time for transient falling
edge
0.01ms
Trigger Function Trigger function selection Tran
*Trigger source Trigger source external
Battery Mode Battery discharge
operation
off
Battery mini voltage Battery minimum
termination voltage
0V
Battery discharge current Battery discharge current 0A
Voltage on Von point for the load 0V
Voltage on Latch Latch the Von point Off
* indicates it only can be programmed in the remote control.
The 10 groups of parameters stored in Location 0~9 can be saved and recalled by pressing
key +
key and key + key, or via the remote command (*SAV < NRl > and *RCL
< NRl >).
The parameter saved in Location 0 will be recalled automatically every time the load is turned on.
2.12 Reading Remote Programming Errors
The Err annunciator will be turned on when remote programming errors occur. The error codes
are shown as followings:
 -lxx Command errors
 -2xx Execution errors
 -3xx Device-specific errors
 -4xx Query errors

Array electronic 372 Series Specifications

General

Brand	Array electronic
Model	372 Series
Category	Power Supply
Language	English