Need help?Do you have a question about the ARRI M18 and is the answer not in the manual?
General| Power | 1800 W |
|---|---|
| Lamp Type | Metal Halide |
| Color Temperature | 6000 K |
| Beam Angle | 20 - 60° |
| Protection Class | IP23 |
| Mount | 28 mm Spigot |
Provides advice on safe operation of ARRI lamp heads and general safety requirements for qualified personnel.
Outlines hazard symbols, warnings, and safety requirements for transport, setup, and operation of lamp heads.
Details safety measures for electrical connections, including grounding, circuit breakers, and protection devices.
Instructions on removing the lens door and safety glass, including notes on handling and cleaning.
Guidance on reassembling components correctly, emphasizing the safety switch activator's position.
Steps to remove the reflector using Torx 20 screws and how to clean it properly.
Procedure for removing the Safety Switch Activator (SSA) by loosening nuts and worm screws.
Instructions for adjusting the door latch using a screw and checking the gap for proper function.
Steps to correctly position and tighten the SSA, and how to test its adjustment for proper click sound.
Procedure for removing the SSA backwards into the housing and unscrewing housing screws.
Instructions on how to remove the housing from the stirrup and disconnect the lamp holder assembly.
Steps to remove screws from the front and back of the base group to access and pull out the ignitor assembly.
Tips for reassembling the base group and housing, including loosening skid screws for better fit.
Instructions on removing covers and screws to access and disconnect the lamphead connector cables.
Steps to remove components like lens door, reflector, SSA, housing, and screws to slide out the stirrup.
Recommendation for regular visual inspection to detect potential damages early and prevent consequential damage.
Guidance on regularly cleaning the UV protection glass, reflector, and inner housing for longevity and safety.
Checks for the safety switch functionality (clicking noise) and lamp socket condition (burn marks).
To Next Page
