Installation and Overview
VAP3400/3402 802.11ac Wireless Video Access Point • User Guide 7
Step 2: Install the Client
1. Connect the second VAP unit to your set-top box with the provided Ethernet cable. Before you connect the
VAP, ensure your set-top box is powered on.
Note: While you are required to connect your VAP to a set-top box to ensure the Access Point properly
streams video to the Client, the VAP’s extra Ethernet port (VAP3402 only) provides you with the option of
connecting other devices to the unit as well, such as computers and gaming consoles.
2. Connect the power adapter to the VAP, plug the adapter into a wall outlet and set the Power switch to the
ON position. You’ll see the power LED on the unit’s front panel light green, indicating the unit is powered.
3. After applying power, check that the 2 Ethernet port LEDs are (1) solid green and (2) blinking yellow.
4. Wait until the Operational Mode/WPS Status LED is solid blue (approximately 1-2 minutes).
5. The devices come Pre-Paired, so they will automatically establish secure communication with no further
interaction required.
To Next Page
Loading...
