15A2135L 36
Uncertainty: Omit
Change? (Yes/No)
or
Uncertainty: Include
Change? (Yes/No)
These prompts relate to the status of the Uncertainty setting for the
Printout.
Press NO to keep the Uncertainty as displayed. Press YES to change the
Uncertainty to the alternative selection. See Appendix B for an example
Printout.
6.10 Signature Block (available in version 7A2.1XX or newer firmware)
The Signature Block menu entry allows the display “Performed By:” and
“Reviewed By:” signature lines to appear on the Printout. Each line will
also contain a “Date:” section for recording the date. Access this option
using the Setup Menu. (Refer to Section 6.1, “Instrument Setup Menu.”)
Press YES at the prompt:
Signature Block?
To skip this setup option, press NO.
If YES is pressed, the following prompt will be displayed:
Sig block: Omit
Change? (Yes/No)
or
Sig block: Include
Change? (Yes/No)
These prompts relate to the status of the Signature Block setting for the
Printout.
Press NO to keep the Signature Block as displayed. Press YES to change
the Signature Block to the alternative selection. See Appendix B for an
example Printout.
To Next Page
Loading...
