30
Adjusting the Set Temperature
To display the set temperature, press the
Up
or
Down
key button once.
To change the set temperature, press the button a second time before the LCD stops flashing.
Use
Up
or
Down
key to set desired water temperature. The temperature setting will be
displayed for 5 seconds to confirm your new selection.
Modes of Operation
Standby Mode
Standby mode turns off all pumps and heater to allow technicians to work on the spa
without the threat of the pumps or heater turning on.
By default, the system is always on. Press and hold
Pump 1
key for 5 sec. till the “OFF”
message is shown to shut the system down for 30 minutes. The display will toggle between
the “OFF” message, the time, and water temperature. Press any pump key to restart the
system before the expiration of the 30 minutes delay.
Economy Mode
This mode allows you to lower the temperature set point of the spa by 20 °F (11 °C) during a
certain period of the day
.
While the Economy mode is enabled the display will toggle
between “Econ” and the water temperature. Once the system goes back to nomal mode, the
display will show "noE" for 3 sec. Please refer to “
Setting Economy Mode
” for setting of
“Economy Mode”
Smart Winter Mode
Our Smart Winter Mode protects your system from the cold by turning pumps on several times
a day to prevent water from freezing in pipes.
Settings
Setting the Time
Enter Programming mode by holding the Light key
down for 5 sec. The hour will start flashing.
Use
Up
or
Down
arrows to change hour setting, passing the 12’oclock hour to set the
AM/PM
.
Once the correct hour is selected, then press the
Light key
to set. Then the
minutes will start flashing. Use
Up
or
Down
arrows to change minutes. Once the correct
minutes is selected, then press the
Light key
to set. After setting the time, it moves to
setting the Filter Cycle.
Setting Filter Cycles
Once you have set the Time, you should now see “FS_ _”. This stands for Filter Start. Use the
Up or Down arrows to set the hour that you want your filter cycle to start, paying attention to
the AM/PM as well. Once you have the start time selected,
press the
Light key
to set.
To Next Page
Loading...
