37
Figure 11. Drop in filter removal
Figure 12. Empty filter housing
1) Turn off all power to the spa.
2) Unscrew the weir cap(if applicable)
3) Grab and Lift the basket upwards and dispose of any possible debris.
4) Grab and Lift the filter upwards to remove it from the housing.
5) Clean or Replace the filter.
6) Place the filter all the way down back into the housing.
7) Place the basket on top of the filter (as shown in the photo above).
8) Then screw on the weir cap on top of the housing. DO NOT over-tighten!
9) Use of a quality filter soak product is recommended. Please contact your dealer
to purchase spa care products.
These are the steps needed to properly replace the SCREW IN filters. Spa filters should
be cleaned every month and replaced depending on usage.
To Next Page
Loading...
