- 12 -
LEVELING THE BUILD PLATE
The Genius Pro comes with Auto Bed Leveling Sensor, it will perform
a self-test when you power on the printer, if it doesn't, please do
not proceed and check on the cables to make sure they're correctly
seated.
1. Home the printer;
2. Heat up the bed and the hotend to 70 ° C and 240 ° C respectively;
3. Go to Tools -> Level;
4. Slide a piece of A4 paper between the nozzle and the build plate;
5. Move the hotend to all 4 corners to repeat step 6;
6. Turn the leveling knob under the bed closest to the nozzle until the
piece of paper slides, with just a bit of drag;
7. From the menu, go to Tools -> More and click on Auto-Level;
8. The printer will initialize the auto bed leveling procedure, wait till it
finishes;
9. Click EEPROM Save;
10. Do the following only if the nozzle is scratching on the build plate or
the nozzle too far from the build plate;
11. Heat up the bed and the hotend to 70 ° C and 240 ° C respectively;
12. Go to Tools -> More -> Z=0;
13. The nozzle will move to the center and at 0 height;
14. Slide the A4 paper between the nozzle and bed again, use +0.025
and -0.025 button to adjust the nozzle distance from the build plate
until the piece of paper slides, with just a bit of drag;
15. Click EEPROM Save once you’re happy with the drag on the A4 paper;
16. Repeat Step 2 to Step 9.
17. To enable compensation for auto-leveling, add M420 S1 Z10 after
G28 in starting Gcode.
To Next Page
Loading...
