• Delay [LFO 2 only] delays when LFO starts and also fades it in
gradually.
• Rate sets the frequency of the LFO. The light to the left of this knob
flashes with it (until the setting gets too high and the light remains
solid).
• Seq-Sync locks the LFO's tempo to the Sequencer See Sequencer
Section [p.41], which in turn can be synced to various sources.
• Retrig cycles through the three choices for how the LFOs respond to
note triggers/retriggers:
◦
Off
- The LFO keeps oscillating continuously on its own,
independently of whether notes are triggered; This mode
simulates a traditional analog LFO.
◦
Single
- The LFO goes through its wave one time only after
a note is triggered. This is useful for creating an interesting
note attack, among other applications.
◦
Multi
- The LFO starts its cycle over every time you trigger a
note.
4.12. Filters
Steiner Filter (VCF 1) and Ladder Filter (VCF 2)
30 Arturia - MatrixBrute Manual - Operation
To Next Page
Loading...
