5.4.6. Att 1 > Cutoff
This parameter provides another method of modulating the filter cutoff frequency. It is pre-
wired to control the amount of pressure-sensitivity that will be applied to the filter, but the
patch bay can be used to route another input as the modulation source.
The "Att 1" portion of the label stands for "Attenuator 1". The patch bay has a section labeled
"Attenuators", and when a different source is routed to the first pair of connectors there, that
input source becomes the modulator for which the Att 1 > Cutoff knob sets the modulation
range. There's more to say about using the patch bay and the Attenuators [p.76], and we'll
cover that in the patch bay chapter [p.58].
38 Arturia - User Manual MiniBrute 2S - The top panel
To Next Page
Loading...
