Arturia MINIBRUTE 2S - The FILTER Jacks

7.5. The FILTER jacks
7.5.1. FM input
The ADSR envelope is the pre-wired source for the Filter cutoff Frequency Modulation jack
(FM), but another source can be used by plugging a cable into this jack. The new control
signal will modulate the Filter cutoff frequency in the amount set by the FM knob in the Filter
section.
Remember that in order for modulation of the Filter cutoff frequency to occur, the FM knob
must be set to a non-zero value.
7.5.2. RM input
LFO 1 is routed to the Resonance Modulation parameter by default, but when another source
is plugged into this jack it will become the modulation source instead.
Remember that in order for modulation of the Filter resonance level to occur, the RM knob
must be set to a non-zero value.
7.5.3. Cutoff
The Filter cutoff frequency can be modulated by any source that is patched into this
connection. The depth of the modulation is controlled by the Att 1 > Cutoff knob in the Filter
section.
The Filter section
70 Arturia - User Manual MiniBrute 2S - The Patch bay