7.12.3. Out 1 > Cutoff (Att 1)
This jack will provide the attenuated output of the source that was connected to the In 1 jack.
Route it to the desired destination parameter and then control the amount of modulation
with the Att 1 > Cutoff knob on the front panel.
♪: Read the Using the Attenuators [p.76] section for essential information about routing a signal
through the Attenuators.
7.12.4. In 2 (Att 2)
Patch the output of the signal you want to control into the In 2 jack and then use the Out 2
> Amp jack as the source for the desired destination parameter. To control the level of the
modulation, use the Att 2 > Amp knob in the AMP section.
7.12.5. Out 2 > Amp (Att 2)
This jack will provide the attenuated output of the source that was connected to the In 2 jack.
Route it to the desired destination parameter and then control the amount of modulation
with the Att 2 > Amp knob on the front panel.
♪: Read the Using the Attenuators [p.76] section for essential information about routing a signal
through the Attenuators.
Arturia - User Manual MiniBrute 2S - The Patch bay 77
To Next Page