ARUSNAVI ELECTRONICS ARNAVI 5 - Page 20

USER MANUAL [1.4]
Page 20
To receive information on the SIM card of the device, the function of sending SMS messages
must be enabled.
Table 3 – Default device settings (factory settings)
Parameter
number
Description
Default value
#1
Monitoring
server address
1
hw.geliospro.ru,20144,0
#2
APN parameters of the
SIM card’s mobile
operator 1
No parameters are specified; automatic mode
#5
Trajectory processing
parameters
400,18,20,150 (transmission of the point to the
server when passing a distance of 400 m,
changing the course by 18 degrees or changing
the speed by 20 km/h, and also at least once
every 150 seconds)
#7
APN parameters of the
SIM card’s mobile
operator 2
No parameters are specified; automatic mode
#12
Changing the number of
the CAN bus handler
Information SMS messages
The device is able to send a set of SMS messages with information about operation. To receive an
information message, send a corresponding request:
<access_password>*SMSI – receive SMS with IMEI;
<access_password>*SMSK– receive SMS with coordinates and a link to the map;
SMS with the answer will return to the number of the sender of the request.