DESCRIPTION OF PARAMETERS IN THE WIALON SYSTEM
External power supply voltage
Horizontal Dilution of Precision
GSM Base station unique ID
Range from 1 to 31 (99 – no service)
0 – turned off, 1 – turned on, 2 – AT Ok, network
search, 3 – GPRS test, 4 – GPRS OK
0 – turned off, 1 – turned on, 2 – satellites search,
3 – satellites captured
Accelerometer sensor state
0 – no SIM, 2 – network search, 1 – home
network, 5 - roaming
0 – no SIM, 2 – network search, 1 – home
network, 5 - roaming
0 – not defined, 1 – connection attempt,
2 – connection established
0 – not defined, 1 – connection attempt,
2 – connection established
1 – activated, 0 – not activated
Считывается с IN4(при подключенном CAN –
считывание ведется с CAN-шины)
1 – installed, 0 – not installed
1 – pressed, 0 – not pressed
Full mileage according to the GPS
module
Frequency value on discrete input
X – input number (For example, freq_4 –
IN4(A4))
Displays the reason for recording a new package
Voltage value on analog input
X – input number (For example, volt_4 –
IN4(A4))
Bitwise parameter
(inX/outX state)
Bitwise state of discrete sensors (for
inputs IN0-IN9, number IN+1).
For example, to monitor the status of IN4, the
parameter to create the sensor pin:5 (which
means: control the fifth bit of the parameter ‘pin’)
X – number IN (IN0(device)= in0 in Geliospro)
X- register number( 0-19)
X – discrete input number
X – temperature sensor number
To Next Page
Loading...