3.Network Mode : Connect your phone to SoundSystem WiFi.
3.1. Go for mobile device WLAN settings> Connect mobile device to WiFi hotspot SoundSystem_xxxx you will see a WiFi logo . (short press the reset
button if the Wi-Fi hotspot is not found)
3.2. Open the 4STREAM application, follow the guides
3.3 Choose the 2.4G network(first-time connection require connect your router 2.4G channel), enter router password>wait for the device to be
configured.
* For multiple units connecting to same router, router password will be saved.
*If change router or router password, please press WiFi reset button on the product.
*Attention for Android users Different brand mobile phones may ask you to allow to use SoundSystem WiFi network, please choose yes, if not, you
may not able to set up successfully. It may also ask you to authorize other things, please choose yes or it may affect your use.
5.3 Connection via LAN
Plug in the wired cable to the RJ45 Ethernet, the device will show on the app in about 10 seconds. (Note: the cell phone and the device must be in the
same network)
5.4 Bluetooth
To use Bluetooth, please switch to Bluetooth via app or by remote controller, then find Bluetooth device SoundSystem_XXXX from your phone
Bluetooth setting and pair it.
5.5 USB audio
Power up and connect the Up2Stream AMP to your PC with USB cable (make sure it’s a data cable including the signal wires). The PC will
automatically discover a USB sound card, and when you activated it as the system main output, the PC will send the audio output over Up2Stream
AMP in digital (44.1KHz/16bits).
You can stream to other Up2Stream devices over the multiroom connection.
NOTE: there’s about 3 seconds delay for multiroom slave devices.
To Next Page
Loading...
Need help?
General
