14
For mowing, always turn the accelerator lever
to full throttle to achieve the best mowing
performance.
To avoid blockage during the ejection of
grass, we recommend, for flat terrain, to
proceed according to the mowing patterns.
Mulch is shredded into much smaller pieces
when you mow the terrain once again in the
opposite direction.
If the grass is extremely high, mow twice at
different cutting height settings.
Prior to starting
Fuel
Use a mixture of two stroke oil and unleaded
petrol (octane rating at least ROZ 91).
For mixing ratio, see chapter Mixing ratio fuel.
Recommendation: Two stroke oil TITAN 2T
100S, mixing ratio 1:100.
Your advantages:
Halve oil consumption compared to 1:50
– more environmentally and cost friendly.
Optimum protection of the engine for a
long service life.
You can buy Fuchs “TITAN 2T 100S” from
your AS-dealer:
Container
Spare part
no.
1 litre
(resealable bottle)
100 ml
(disposable container)
40 * 100 ml
(disposable containers in box)
E06830
E10286
E10561
Notice: You can find on the market ready
mixed two stroke fuels. Based on our
experience, the ready mixed fuels “STIHL
Motomix 1:50” and “ASPEN 2-stroke” can be
used. No guarantee can be given for
operation of the device with other fuels and
oils!
Storing fuel mixture:
The fuel mixture ages and can cause engine
damages. Only mix as much fuel as you are
going to use up during the next mowing.
Tanking up
Danger!
Fuel is ignited by hot engine parts.
Prior to filling up, switch off the
engine and wait for at least
20 minutes until the engine has
cooled down. Observe the safety
instructions regarding the fuel!
Filling in the fuel:
1. For filling, use a canister with a filler
spout or use as funnel.
2. Open the canister carefully so that the
existing overpressure is discharged
slowly and no fuel spurts out.
3. Open the tank cap carefully so that the
existing overpressure is discharged
slowly and no fuel spurts out.
4. Fill the fuel tank.
5. Screw the tank cap on tightly.
Adjusting cutting height
Adjust the cutting height setting only when
the engine is switched off.
Set the cutting height so that the blade does
not touch the ground even in case of terrain
unevenness. If the cutting height is set too
high, objects can be ejected and the “clean
cut appearance” can be destroyed.
To Next Page
Loading...
Need help?
General
