16
Adjusting speed:
The driving speed can be continuously
adjusted with the vario lever.
Adjust the driving speed only when the
engine is running.
The front axle is equipped with a permanent
differential lock. This increases traction and
driving stability of the device. Danger of
slipping is reduced.
Driving in reverse
Danger!
Risk of injury caused by tripping or
slipping while moving in reverse or
while turning.
Make sure that path is free of
obstacles and ensure safe footing.
While driving in reverse, only the two front
wheels are driven. Reverse speed is half of
the forward speed.
Reverse drive on:
1. Release the drive lever.
2. Press the lever for reverse gear towards
the handlebar - device drives in reverse.
Reverse drive off:
1. Release the lever for the reverse gear.
Turning
Turn the device round only where the grass
has been mowed already.
Turning round on an even surface:
1. Switch off the drive.
2. Turn the device to the desired side.
3. Switch the drive back on.
Turning round on a sloping area:
1. Keep the drive switched on.
2. Turn the device upslope.
3. Hold back the handlebar and the inner
wheel.
The drive prevents sliding and supports the
turn manoeuvre.
Switching off and parking
Caution!
On a slope, the device can roll
away.
Put the device on even ground
only or secure it against rolling
away.
1. Release the drive lever.
2. Turn the accelerator lever to the lowest
engine speed.
3. Release the engine brake lever.
4. Wait until the blade comes to a standstill
before you step away from the device.
5. Close the fuel valve and the tank
ventilation.
6. Pull off the plug connector.
To Next Page
Loading...
Need help?
General
