2
1 • IDENTIFICATION OF MODEL
Model code
Input X
OPZIONI
1.2 Configuration code
Configuration code
Beginning and end of
scale
Auxiliary output Y2
Auxiliary output Y3
Retransmission output Y4
Beginning and end of scale
(for configurable scales only)
1
st
part
Set point W
2
nd
part
Main output Y1
The controller is normally configured in the factory.
!
If this appears on starting
the controller IS NOT CONFIGURED
In order to configure the controller, follow the
configuration procedure reported in the enclosed leaflet
F G HE
I L M N
O P
9.999
9999
C0
E
F
G
H
I
L
M
N
O
P
275.8
275.8
50
4
To Next Page
Loading...
Need help?
General
