OPERATING MANUAL
7610-4700-1201
Issue A
3-5
• WACK
• Analog ANI identity number
is seen under this sub menu.
Software:
Radio software version and date info is given under this menu.
Hardware:
Radio device, board base version info is given under this menu.
Battery Info:
Charge percentage, voltage level, temperature of the battery, drawn current info, charging
number, type, capacity and identity info is given under this menu.
Measurement:
RSSI Level: Broadcast signal level at the channel is seen as dBm.
Display GPS Data: If GPS is connected to the radio; position info read from GPS receiver
is shown as latitude, longitude and GPS clock info is shown as hour:minute:second.
Supply:
Power supply value is given at this menu.
3.7 SCAN MENU
Shortcut: 7
Channel List:
It occurs from simplex and unique repeater channels with 25kHz channel spacing at
analog mode, 12,5kHz channel spacing at digital ctrypted mode.
Channel list determines the priority of the calls received by the radio in channel scan
mode. Analog channel scan can create 1 first priority channel and 1 second priority
channel. During scanning if a call is received from second priority channel, radio leaves
the ordinary channel and goes to the second priority channel and meanwhile it goes on
checking if there is a call from first priority channel.
If it received a call from first priority channel, it leaves the second priority channel and goes
to first priority channel. And it does not interest in other channels until the call at this
channel is finish. When radio receives a broadcast that it can not allow user to listen it
(different tone at analog channel, different group no at digital channel) it goes on scanning
process. Channel scanning becomes unfunctional when a digital or crypted call has been
started to listen at channel.
( - ), ( + ), ( 1 ), ( 2 ) signs take place near the channel number at the list.
• (-) sign means that, channel does not included by the scanning list,
• (+) sign means that, channel included by the scanning list,
• sign means that, this channel is first priority channel during scanning,
• sign means that, this channel is second priority channel during scanning.
To Next Page