OPERATING MANUAL
7610-4700-1201
Issue A
6-2
• ‘OK’ pressed.
After the call alert has been transmitted, caller radio's identity appears at the receiver
radio's display and an audible alert is heard.
6.6 PHONE CALL
Radio demands one-to-one communication at Digital / Crypted Mode by phone call. To
start phone call at the authorized radio:
• ‘# # #’ is dialed,
• Required phone number is dialed,
• ‘OK’ is pressed.
Phone call is made as uni-directional. If PTT Button is pressed, it makes transmission to
phone network and if PTT button is released it listens to the broadcast from phone
network.
Phone call is terminated if phone is closed or button is pressed at radio.
6.7 PRESENT STATUS
Radio user's status info can be selected among the status defined at radio. To select
status info:
• ‘#’ is dialed,
• Required status info between “01-15” is entered,
• ‘OK' is pressed.
If radio is turned off and turned on again, status info is deleted.
6.8 SEND STATUS
To send active status info to another radio user:
• 'Send Status' sub menu is selected from ’Status' menu,
• Radio ident to which the info will be sent is entered,
• ’OK' is pressed.
6.9 STATUS REQUEST
To request the status info of a radio under the system:
• 'Status Request' sub menu is selected from ’Status’ menu,
• Radio ident from which the status info will be requested is entered,
• ’OK' is pressed.
6.10 SHORT MESSAGE (SMS)
Authorized radio can send maximum 160 characters message, which is entered by keypad
to another radio or administration center. Received and sent messages can be seen under
'SHORT MESSAGE' menu.
To Next Page