OPERATING MANUAL
7610-4700-1201
Issue A
6-4
SC number is given to the radios that have selective call property. SC number is a 2-6 digit
number and can be selected by programming. Each radios SC number is given by a
method that when the last digits are used together it creates a group. In this case groups
are obtained with user number 9, 99, 999, 9999, 99999. SC started to group means that
the call is started to every radios whose SC numbers are starting same. During
programming, group tone at group identity entrance is determined as "0" or "A":
If group tone is programmed as "0" identity is entered as 22000.
If group tone is programmed as "A" identity is entered as 22GGG. thus caller radio dials
group identity as 22***.
To start selective call '#' key is pressed at analog mode and SC number of the other radio
is entered at the screen. Call has begun as soon as the all digits are entered.
While dialing the SC number, the number at the left side of the cursor is deleted by
pressing
button.
6.15 TONED CALL
At analog mode channel, if channel is being shared by a lot of user, toned call is used to
achieve communication of the user groups without listening each other when the channel
is not busy. If Tone Code Squelch/Selective Call is disabled by Monitor/Option Button
whole communication at the channel can be listened.
By tone Code Squelch, tone is added to channel's receiver and transmitter frequencies.
Radio receiver only turns on when it gets this tone. Channel tone info is entered with the
frequency info during programming.
6.16 REGISTERING
Radio must be registered to the system to be able to get service from system channels.
After turning on the radio and entering PIN info, radio is registered to the system
automatically. Registered site is appeared at the lowest row of the radio's display.
If radio get out of the site coverage area and enter another site's coverage area it
registered to the new site automatically. Thus user can get service from new system
without changing the channel.
6.17 CALLER IDENT
Radio displays the caller radio's system ident at system or direct mode digital channels; at
analog channels it displays the caller radio's ANI number. For analog ANI display, radio
ANI display must be programmed to the radio.
6.18 REPEAT CALL
If call short message can not be sent because of a barrier it has repeated for 4 times to
establish communication.
6.19 CHANNEL MODE ACCESS
Radio user can follow the call that is has transmitted/received is digital/crypted from
display.
To Next Page