OPERATING MANUAL
7610-4700-1201
Issue A
6-3
To send short message:
• ‘SMS EDIT’ sub menu is selected from ‘SMS’ menu,
• Message (maximum 160 characters) is written by alphanumerical keypad,
• ‘OK' is dialed and then the radio ident or center number to which the message will be
sent is entered is entered,
• Message is send by pressing ‘OK’ button.
6.11 PROGRAMMED MESSAGE
Radio can send programmed messages, which are determined during programming, to
another radio or administration center. Received and send programmed messages can be
seen under 'PROGRAMMED MESSAGES' menu.
To send programmed message:
• 'MESSAGE LIST' sub menu is selected under ‘PROGRAMMED MESSAGES’,
• Required message is selected by up , down buttons and 'OK’ key,
• Radio ident or center number to which the programmed message will be sent is
entered,
• Programmed Message is send by pressing ‘OK’ button.
6.12 DATA SERVICES
Message, status message transferred and data communication can be achieved by radio.
6.13 ANALOG CALL
At analog mode channel, when PTT Button is pressed radio makes transmission through
the channel and it gets the analog broadcast at the channel.
6.14 SELECTIVE CALL
At analog mode channel, radio starts a call to another radio by dialing selective call
number. This call's difference from general call is to warn that user to listen carefully. This
call is heard by all radios at the channel.
ANI: Radio's identity info.
SC: Radio's selective call number.
ACK: When radio gets a selective call it sends this number the radio to inform that it has
got the call.
Against the caller radio ANI number and SC number of the radio that it is calling, called
radio responds with its ANI number to inform the caller radio that it has received the call. If
selective call is started to a group ACK is not waited. ANI, SC tone sequences are
displayed as the talking radios identity. To be abler to make selective call radio must be
authorized and at channel parameters, ANI at that channel must be marked.
When SC is received by a radio only the caller radio's ANI info appears at the display.
To Next Page