11
Customer Care Center
1-800-898-1879
www.askousa.com
Press start
The dishwasher will now start. It man-
ages the entire wash automatically. Ensure
that the door is properly closed or the ma-
chine will not start.
The display shows ‘Program started’. If the
door is open or not properly closed, ‘Close
door’ appears in the display.
Changing program
If you wish to change the program after
having started the machine, press the Start/
Stop button for three seconds. Then select a
new program and press the Start/Stop but-
ton again.
Do you want to load more dishes?
Carefully open the door; the machine will
stops automatically, put in the dishes, close
the door and the dishwasher will continue
from where it left off.
If the machine is switched off at the
main switch
(or in the event of a power cut) before the
washing program has been completed, the
interrupted program will continue when the
power comes back on.
NB!
If the power is switched off, or if the door
is open during drying, the program is inter-
rupted.
Standby mode
Once the machine has finished, it is drawing
a very small amount of power. Disconnect
the power by switch off at the main switch.
Turn off the water tap if the machine is not to
be used for an extended period, e.g. during
holidays.
The indicators around the Start/Stop
field gradually light up as the programme
progresses.
When the programme finishes, all the indi-
cators are lit, turning off 2 hours later.
7
To Next Page
Loading...
Need help?
General
