34
Customer Care Center
1-800-898-1879
www.askousa.com
WATER CONNECTION
• The machine can be connected to a cold or
hot water supply (maximum 140°F, 85°C).
However, we recommend connection to a
cold water supply.
• The inlet pipe has a connector with either a
9/16” internal thread.
ELECTRICAL CONNECTION
• 120VAC mains voltage, minimum 15A.
DRAINAGE
• The supplied cone-shaped connector ts a
drain connection with an internal diameter of
1/2, 5/8, 23/32 and 7/8 inches (13, 16, 18 and
22 mm).
• Use a hose clamp if connecting to a xed drain
(sink).
The connector is ready to cut to the desired
drain connection size. Only a clamp is required.
CABLE/HOSE LENGTHS
Drain hose: 59 inches (1930 mm)
Supply hose: 64 inches (1670 mm)
Power cable: 45 inches (1770 mm)
TOOLS
1) Flathead screwdriver
2) Open-ended wrench
5/8 inches (16 mm)
3) Tape measure
4) Spirit level
Installation and connection information
To Next Page
Loading...
