35
Customer Care Center
1-800-898-1879
www.askousa.com
Step 1. Fitting the dishwasher in place
1. Loosen the mounting screws on the dish-
washer’s two front steel feet using a 5/8 inch
(16mm) open-ended wrench. Screw the
mounting screws down as close to the oor as
possible.
2. Adjust the height of the dishwasher by turn-
ing the front steel feet with your hands. Leave
enough space to adjust them later.
3. Screw in the back foot completely by turning
the adjustment screw at the front counter-
clockwise. Use a at-bladed or a 1/4 inch nut
driver.
To Next Page
Loading...
