10
Using the programmer
How to set the time
When plugged in
The display flashes 12:00.
Set the time by pressing the + or – buttons
(holding your finger on the button allows
you to scroll through the numbers rapidly).
Example: 12H30
Press the “ ” button to confirm.
The display stops flashing.
To set the time on the clock
The function selector switch must be
in the 0 position.
Press and hold the “ ” button for a few
seconds until the display starts flashing,
then release.
Audible beeps indicate that it is now
possible to set the time.
Adjust the clock setting with the + and –
buttons.
Press the “ ” button to confirm.
Warning
If there is no confirmation from the
“ ”, button, the time is recorded
automatically after a few seconds.
2
1
Using your appliance
To Next Page
Loading...
