24
USE
Motor enable
The engine must be enabled to start.
To enable the engine, insert the key into the switch
and turn it to
, then press for 3 seconds to enable
the engine, motion warning light will turn on.
To disable the engine, press the engine enabling
button again for 3 seconds and turn the key in the
ignition switch to the left on
.
The engine will be disabled also by rotating the key
to
.
P
U
S
H
I
G
N
I
T
I
O
N
NGS1 - NGS2 NGS3
NGS_Rev00_EN.indb 24NGS_Rev00_EN.indb 24 05/06/2020 11:28:1105/06/2020 11:28:11
To Next Page
Loading...
