EasyManua.ls Logo

Askoll NGS3 - Reconnecting Charger to Vehicle

Default Icon
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
BATTERY AND RECHARGE
EN
EN
EN
EN
EN
CAUTION
The battery charger is not intended to be used by persons with reduced physical,
sensory or mental capacities, or lack of experience or knowledge, unless a person
responsible for their safety has supervised or instructed them concerning the use
of the charger.
Keep the battery charger and batteries out of the reach of children, make sure that
they do not play with the devices.
CAUTION
Risk of electric shock
This device is equipped with a 3-pole plug with grounding contact. Make sure that
the power outlet has 3 pins and grounding contact. If not, contact an electrician
to replace the outlet.
Do not try to neutralize the grounding contact safety of the 3-pole plug.
Connect the device to a power supply network protected by a differential switch
with a sensitivity not exceeding 30mA.
The electrical connection of the device must comply with the details on its
electrical data label.
Do not use extension cords. If the length of the power cord is not sufficient,
consult an electrician or qualified installer.
Do not cut or repair the power cord.
The power cord of this device is of special type: if it is damaged it must be
replaced by the manufacturer, or by its service centre or by an operator with
similar qualification, in order to avoid all risk.
CAUTION
The battery chargers model TC202 and TC203 are intended to be used exclusively
for charging batteries model TVC102 and TVC103 in indoor environments. Do not
use the battery charger for purposes other than those specified.
NGS_Rev00_EN.indb 37NGS_Rev00_EN.indb 37 05/06/2020 11:28:3305/06/2020 11:28:33

Table of Contents

Other manuals for Askoll NGS3

Related product manuals