Operating the F100
Page 4-16 F100-14-001.2
ASL 2005
b) Calibration
Selecting this option allows the F100 to be calibrated; this procedure will overwrite and replace
the exiting calibration data. The correct equipment, environment and accurately calibrated
resistors are required.
Note
Selecting this option will overwrite the instrument calibration
data. Do not attempt to do this unless you have the corr ect
equipment, environment and suitably trained personnel.
The procedure is covered in separate documentation and requires a passcode to for entry.
c) Reset defaults
The instrument parameters can be set to the factory defaults. Selecting this option will
overwrite any existing (passive probe) coeff ic ient data and reset the default values for the
operational details. To gain access, a pass-codes must be entered first.
Note
Selecting this option will overwrite all probe calibration data
and settings. Do not attempt to do this unless you have the
correct equipm ent, environment and suitably trained
personnel.
&K DQ JH3D VV FR GH
&K DQ JH3D VV FR GH&K DQ JH3D VV FR GH
&K DQ JH3D VV FR GH
&D OL EUDWL RQ
&D OL EUDWL RQ&D OL EUDWL RQ
&D OL EUDWL RQ
)D FW RU\' HI DX OWV
)D FW RU\' HI DX OWV)D FW RU\' HI DX OWV
)D FW RU\' HI DX OWV
'L DJ Q
'L DJ Q'L DJ Q
'L DJ Q R VW LFV
RV WL FVRV WL FV
RV WL FV
3 DV VFRGH
3 DV VFRGH 3 DV VFRGH
3 DV VFRGH
8S ' RZQ FK DQJ HV
8S ' RZQ FK DQJ HV8S ' RZQ FK DQJ HV
8S ' RZQ FK DQJ HV
(Q WH U
(Q WH U(Q WH U
(Q WH U
VHO HF WV
V HO HFWVV HO HFWV
V HO HFWV
&O HD UFRH II ·V
&O HD UFRH II ·V&O HD UFRH II ·V
&O HD UFRH II ·V
5H VW RUH ID FW RU\
5H VW RUH ID FW RU\5H VW RUH ID FW RU\
5H VW RUH ID FW RU\
' HIDXO WV "
' HIDXO WV " ' HIDXO WV "
' HIDXO WV "
(Q WH U
(Q WH U(Q WH U
(Q WH U LI <HV
L I <HVL I <HV
L I <HV
&O HD UIRU
&O HD UIRU&O HD UIRU
&O HD UIRU 1 R
1 R1 R
1 R
To Next Page
Loading...