V2000 – Installation Guide
U-0623-0291.docx – Issue: 04 complete, approved
Page 36 of 40
10 Packing for Return
The V2000 mainframe, interface cards and amplifier modules contain static-sensitive devices.
Observe ESD precautions when handling the mainframe with the lid removed, the interface cards
or amplifier modules.
If a product is being returned for servicing, try to use the containers and materials of the original packaging.
Attach a tag indicating the type of service required, return address, equipment type and full serial number.
If the original packing can no longer be used, the following general instructions should be used for repacking
with commercially available materials:
• All electronics assemblies must be properly packed in ESD protective packing for transport, to prevent
physical and ESD damage.
• The filler material used for packing must be antistatic or static dissipative, as this may come into contact
with exposed connectors, wiring, or PCB assemblies. The use of non-conductive filler material may
cause damage to the electronic assemblies reducing their operational life, or even destroying them.
• Use a sturdy cardboard box that will support the weight and size of the equipment.
• Attach a tag indicating the type of service required, return address, equipment type and full serial
number.
• Completely wrap the equipment in bubble wrap (all sides must be protected) and secure the wrap in
place with tape.
• Place the wrapped equipment inside the box surrounded by filler material, ensuring that there is no room
for movement.
• Seal the box securely with packing tape.
To Next Page
Loading...
