V2000 – Installation Guide
U-0623-0291.docx – Issue: 04 complete, approved
Page 8 of 40
4 Unpacking and Handling
1. Observe any markings or warnings on the package prior to handling and opening.
Do not use the handles to lift or carry the mainframe. The handles are designed for sliding the
unit into and out of the equipment rack, and not to support its weight.
Use the underside edges of the mainframe to lift and carry it.
Check the equipment package for signs of damage during transport. Report problems to the carrier or
supplier.
3. Unpack the equipment in a dry area handling the equipment with care.
The V2000 mainframe, interface cards and amplifier modules contain static
-sensitive devices.
Observe ESD precautions when handling the mainframe with the lid removed, the interface
cards or amplifier modules.
Check the equipment package contents for completeness. Report any missing items immediately.
V2000 package contents:
• 1 x V2000 mainframe (fitted with handles)
• 1 x V2000 front panel
• 3 x Surveillance Blanking Plates (fitted)
• 2 x Standby Blanking Plates (fitted)
• 1 x mains cable (one end terminated IEC 60320 C19 female connector with and
end)
• 1 x IEC 60320 C20 straight cable mount connector (16 A / 250 V AC)
• 1 x 2-way Phoenix plug
• 1 x V2000 Installation Guide
It is advisable to retain the original equipment packing (containers and materials) in the event that the
equipment ever needs returning for service.
If the packing is not to be retained, the packing materials should be either recycled or disposed of
according to local regulations.
Ensure that the name and address of the Authorised Distributor from whom you purchased the
product
is recorded on the ‘Service and Warranty’ page of this document for future reference.
8. Repacking instructions are provided in Section ‘10 Packing for Return’ (page 36).
To Next Page
Loading...
Need help?
General
