SECTION 6 PREVENTIVE MAINTENANCE
_______________________________________________________________________
6-1
SECTION 6
6 PREVENTIVE MAINTENANCE
INTRODUCTION
The BIS VISTA system is designed so that no periodic adjustment or calibration is required.
Suggested routine maintenance covered in this section includes:
• Periodic checking of cable integrity
• System checkout
• Checking the battery
• Checking leakage current
Instructions on replacing cables, connectors, the battery, the power supply and the clamp
shoe are included in Section 8, “Servicing the BIS VISTA System” if replacement is
necessary. In the event that the touch screen needs calibration, follow the instructions in
Section 8.9, “Calibrating the Touch Screen.”
6.1 Physical Integrity Inspection
Periodically check the system (BIS VISTA monitor, BISx, PIC) for physical damage to cases
and associated cables and connectors.
1. Inspect the cases of the monitor and the BISx to ensure that plastic is not cracked or
broken.
2. Inspect the gasket seal around the case joining surfaces to insure the integrity of the
splash resistance seal.
3. Inspect the cables and strain relief mechanisms.
4. Inspect the connectors for damage, faulty strain relief or contamination.
6.2 System Checkout
A system checkout should be done periodically to verify that all system components are in
working order. To test the system from the BISx to the BIS sensor, you will need a Sensor
Simulator (Part Number 186-0137) or a Test Sensor (See Appendix I for more information).
Follow the instructions below for System Checkout.
To Next Page
Loading...