mains supply wiring system or if the power plug is not suitable for
the type of power point available, it is recommended that a
qualified technician be called to carry out substitution.
The technician will also have to verify that the cross-section of
the electric cables on the power point match the appliance’s
power rating.
REPLACING THE POWER SUPPLY CABLE
Use the same type of power supply cable.
This cable must be connected to the terminal block following
the diagram in fig.23
SECTION OF THE SUPPLY CABLES Type“H05V2V2-F”
resistance to temperatures of 90℃
230V~ 3x0，75mm
2
Connection to a good earth wiring system is absolutely
essential.
The manufacturer accepts no responsibility for any
inconvenience caused by failure to comply with this rule.
Descriptions and illustrations in this booklet are given as
simply indicative.
The manufacturer reserves the right,considering the
characteristics of the models described here,at any time
and without notice, to make eventual necessary
modifications for their construction or for commercial
needs.
To Previous Page
Loading...