User’s instructions
Igniting the burners
In these models the knob controls both ignition and the safety
device. Proceed as follows to ignite the burners:
1) Turn the chosen knob.
2) Keep the knob strongly pressed in for 3/4 seconds to permit
the spark to light the gas
that exits from the flametamer and to permit the thermocouple
to heat up.
3) Release the knob after about 3/4 seconds and adjust the
flame as desired, rotating
the knob anti-clockwise. Repeat points 1 and 2 if the flame
does not remain on.
Using the burners
For greater efficiency and less gas consumption use pots and
pans with the right diameters for the burners. Avoid having flames
extending out from underneath the pans (refer to the table).
Automatic safety valves
This safety device automatically closes the gas valve if the
inconvenience caused by failure to comply with this rule.
CLEANING AND MAINTENANCE
GENERAL
Cleaning and maintenance should be carried out with the
appliance cold especially when cleaning the enamelled parts.
Avoid leaving alkaline or acid substances(lemon juice,vinegar
To Next Page
Loading...