etc.)on the surfaces.
Avoid using acid or chlorine-based cleaning products.
ENAMELLED PARTS
All of the enamelled parts must be washed only with a sponge
and soapy water or with non-abrasive products.
BURNERS AND GRIDS
These parts can be removed and cleaned with appropriate
products.
After cleaning ,the burners and their flame distributors must be
well dried and correctly replaced.
It is very important to check that the burner flame distributor F
and the cap C has been correctly positioned ( fig. 6) -failure to do
so can cause serious problems.
Check that the electrode S is always clean to ensure trouble-free
sparking.
Check that the probe T is always clean to ensure correct
operation of the safety valves ( for models with safety device ).
Both the probe and ignition plug must be very carefully cleaned
GAS TAPS
Periodic lubrication of the gas taps must be carried out by
specialist personnel only.
In the event of operating faults in the gas taps, call the Service
Department.
To Next Page
Loading...