IMPORTANT
√The appliance should be installed, regulated and adapted to
function with other types of gas by a QUALIFIED
INSTALLATION TECHNICIAN.
Failure to comply with this condition will render the guarantee
invalid.
√The appliance must be installed in compliance with regulations
in force.
√Always unplug the appliance before carrying out any
maintenance operations or repairs.
√The appliance must be housed in heat resistant units.
√The walls of the units must not be higher than work top and
must be capable of resisting temperatures of 75℃above
temperature.
√Do not install the appliance near inflammable materials ( eg.
curtains).
INSTALLATION
Foreword:
These tops are designed to be embedded into kitchen
fixtures measuring 600 mm in depth.
In order to install the cooker top into the kitchen fixture, a hole
with the dimensions shown on the cutting size board has to be
made, keeping in consideration the following:
√within the fixture, between the bottom side of the cooker top
and the upper surface of any other appliance or internal shelf
there must be a clearance of at least 30 mm;
√the cooker top must be kept no less than 100 mm away from
any side wall;
√the hob must be installed at least 50 mm from the wall.
√there must be a distance of at least 650 mm between the hob
and any wall cupboard or extractor hood positioned
immediately above.
√It is essential to install a heat baffle between the bottom of the
hob and the underlying unit.
To Next Page
Loading...