ASR emitter - Front panel control knobs of the ASR Emitter

ASR Audiosystems Friedrich Schaefer, D-35727 Herborn, Germany
High End Integrated Amplifier ASR Emitter Page 12
3.2 Front panel control knobs of the ASR Emitter
On-/Off-Selector (= left knob)
Position
(referred to standard
ASR Emiter)
Function
Off The unit is turned off.
Before you switch from „Standby“ to „Off“ please wait at least
20 seconds. The ASR Emitter needs this time, to run a switch-
off-programm.
Standby In this position
- the ASR Emitter can be completely controlled by remote
control
- you can record from source to tape
1 volume can be adjusted from 0 to 61dB, normal operating
position, energy saving mode can be activated
2 volume can be adjusted from 0 to 76dB, energy saving mode
can not be activated.
Additional positions
(for ASR Emitters
with special
features)
Function
A1 (speaker-)outputs „A“, normal perating position
B1 (speaker-)outputs „B“, normal operating position.
Kh the headset-output is active, the speaker-outpu(s) are muted
A2 (speaker-
)outputs „A“, volume control from 0 to 76dB, energy
saving mode can not be activated.
B2 (speaker-
)outputs „B“, volume control from 0 to 76dB, energy
saving mode can not be activated.
A+B1 (speaker-)outputs „A“ and „B“ selected to play together,
normal operating position
If the ASR Emitter is controlled via remote control, the position of the left knob may not
exactly correspond with the actual operating mode. The chosen input is indicated by aN
LED above the (right) input selector knob.
Volume control (= middle knob)
The volume of the ASR Emitter is controlled with a relais step control. The middle knob
works as an impulse sender and can be turned around 360°. The chosen volume will be
displayed in numbers from 0 to 76. In „Standby“-mode the volume can be preselceted up
to 49 – this avoids too high sound pressure levels when turning the ASR Emitter on.
Input selector (= right knob)
In the standard version of the ASR Emitter, the input selector has six positions: six high
level inputs and one tape input. To select an input, please move the input selcetor knob to
the desired input. The chosen input is indicated by a yellow LED.