ASR emitter - Page 21

ASR Audiosystems Friedrich Schaefer, D-35727 Herborn, Germany
High End Integrated Amplifier ASR Emitter Page 21
shielding, the main unit of the ASR Emitter is made of acrylic glass.
RMS output power at 20Hz to 20kHz, 0.1 % distortion, both channels driven:
ASR Emitter I Basic
2x 140 watts/8 ohms, 2x 250 watts/4 ohms, 2x 450 watts/2 ohms, 2x 600 watts/1 ohm
ASR Emitter I Exclusive:
2x 160 watts/8 ohms, 2x 290 watts/4 ohms, 2x 520 watts/2 ohms, 2x 700 watts/1 ohm
ASR Emitter II Basic:
2x 250 watts/8 ohms, 2x 450 watts/4 ohms, 2x 800 watts/2 ohms, 2x 1000 watts/1 ohms
ASR Emitter II Exclusive:
2x 250 watts/8 ohms, 2x 500 watts/4 ohms, 2x 900 watts/2 ohms, 2x 1150 watts/1 ohms
Dynamic output power: about 1,5x RMS output
Distortion: from 50mW to -1dB under RMS output at 1kHz < 0.02%, from 20Hz to 20kHz
< 0.1 %.
Signal-to-noise-ratio: > 90dB (at 1 watt/8 ohms)
Frequency response: -0.1Hz to 500kHz (- 3dB)
Input impedance: 10kohms
Gain: 17dB (in position „1“), 43dB (in position „2“)
Input sensitivity: position „1“ = 2,0V, position „2“ = 0,4V (for 150 watts into 8 ohms)
Separated supplies for
the input stage:
+16 volts/86.000µF (ASR Emitter I) and 152.000µF (ASR Emitter II)
the voltage amplification stage:
+76 volts/40.000µF (ASR Emitter I) and + 96 volts/60.000µF (ASR Emitter II)
the current output stage:
+ 60 volts/400.000µF (ASR Emitter I) and. +78 volts/600.000µF (ASR Emitter II)
Dimensions and weigths:
(W x D x H)
ASR Emitter I:
16,5 x 16,1 x 7,1 inches, 35,3 lbs., Power supply 16,9 x 15,6 x 5,9 inches, 70,6 lbs.
42,0 x 41,0 x 18,0cm, 16kg, Netzteil 43,0 x 32,0 x 15,0cm, 32,0kg
ASR Emitter II:
22,4 x 17,3 x 9,1 inches, two power supplies 16,9 x 15,6 x 5,9 inches/each, 70,6 lbs./each
57,0 x 44,0 x 23,0cm, 40kg, two power supplies 43,0 x 32,0 x 15,0cm/each, 32 kg/each
Note: ASR Audiosystems reserves the right to change specifications without notice
as design improvements are incorporated.