Assa Abloy 1385 - Master;Slave

46
The master/slave configuration menu ( 1385 only) enables you to use
the LED display to identify which slaves are online or offline, or have an
address conflict.
6 5 4
1
2
3
7
8
ye rd
 The LEDs 1 to 8 indicate the
address (LED1 = 1, LED2 = 2,...)
where a device on the bus has
detected the master in the
1385 .
If one of the devices has a
problem (gone offline, address
conflict), the corresponding LED
will flash.
6 5 4
1
2
3
7
8
ye rd
 Turn the key to the right.
 This will indicate which of
the flashing bus devices has
an address conflict. Once you
let go of the key, the display
is updated, so that you can
see whether the bus device in
question is now online again.
Master/Slave